is there any guide some where with the steps to swap the 460, as in oil pan, oil pump, belts and pullys, and all the stuff that goes with it some where on the net???? thanks tower

I'm always leery of a site that starts out, "You need my perches....." Ford made Engine Mounts for the 1973 to 1979 F Series trucks that bolt right into the Bumps. No Drilling, NADA......BOLT IN! Buy them Cheap from the Local Pick and Pull. Transmission needs to be a C-6 that bolts to the 460. The Cross Member that is in your truck already will accept the Transmission Mount Rubber for your year of C-6 Tranny. Nothing else is required except the time to remove the old Engine and Transmission and replace it with the new units. You will find a few odds and ends, possibly, but all should be a bolt in deal.

One thing, though.....This is for the 2wd ONLY! Ford didn't put a 460 in 4wd trucks in the 60's or 70's so they didn't make motor mounts. If it's a 4wd truck you are converting, read the sites with the custom built stuff and figure out what is best for you.

infoford is your best bet he has the attention to detail ive always looked for ive had the "bolt in " l&l stuff its worked but never been to my standard of stock replacement

this thread was started in july

I am betting the OP already solved this